Settings; Communication Port Setting (Com Port Setting) - JRC JMA-5312-6 Instruction Manual

Hide thumbs Also See for JMA-5312-6:

Table of Contents

SETTINGS

This section describes the electrical adjustment procedures to be performed by service engineers during

system installation.

Any adjustments must be made by specialized service

Incorrect settings may result in unstable operation.

Do not make any adjustments during navigation. Failure

to comply may result in adverse effects on the radar

function which may lead to accidents or equipment failure.

External sensor signals are input to the radar equipment through a communication port. The radar

equipment has five communication ports. For signals to be input from sensors or to be output to the

sensors, communication ports need to be set in accordance with the sensors.

[I] Baud Rate Setting

Set the baud rate of the signal to be input to the COM port.

1. Open the Serviceman Menu.

2. Open the Baud Rate menu by performing the following menu

2. Installation Menu

→ 5. COM Port Setting

→ 1. Baud Rate