Setting Of Ccrp (Ccrp Setting) - JRC JMA-932B-SA User Manual

7.1.9

Setting of CCRP (CCRP Setting)

Set the own ship's CCRP location, radar antenna installation location, and GPS installation location.
CCRP:
Radar antenna: Up to eight radar antennas can be input. (Automatically selected in response to ISW
GPS:
Procedures 1. Measure the CCRP location, radar antenna location, and GPS antenna
2. Open the Serviceman Menu.
3. Perform the following menu open procedure to open the CCRP Setting
4. Specify the ship length for Length at the upper right of the CCRP Setting
5. Move the cursor onto the CCRP1 X, Y value, and left-click to input the
6. If it needs to input the second CCRP, click the
7. Repeat the above steps to input the GPS location(s) and radar antenna
8. If multiple CCRP locations are input, left-click to select the used CCRP.
9. Check the checkbox of GPS and radar antenna for all quantities of
10. After setting completion, left-click the
11. When completed the setting change, restart necessarily the power.
Up to four locations can be input. (One location selected when used)
operation)
Up to four locations can be input. (One location selected when used)
location in advance.
menu.
Installation Menu
Menu, and the ship width for Beam.
CCRP1 location.
When X > 0, the CCRP is on the starboard side of the ship.
When X < 0, it is on the port side.
※ Usually, Chart radar works normally when inputting just CCRP1.
display the CCRP2 X,Y value, and input the value in the same manner for
step 5.
Similarly, input the third and subsequent CCRPs.
location(s) for all quantities of installed ones.
installed ones.
→ CCRP Setting
7-7
CCRP2 button to
OK .