Setting Of Ccrp/Antenna/Gps Antenna Position (Ccrp Setting) - JRC JMA-5212-4 Installation Manual

4.7
SETTING OF CCRP/ANTENNA/GPS
ANTENNA POSITION (CCRP SETTING)
Set the own ship's CCRP location, radar antenna installation location, and GPS installation location.
GPS:
Radar antenna: 1 location can be inputted (one master and one slave).
CCRP:
Procedures 1. Measure the CCRP, radar antenna, and
GPS antenna positions beforehand.
2. Open Adjust Menu.
3. Press the following keys.
7. Hull Display Setting
1. CCRP Setting
4. Input the vessel length in the Length field
and the vessel width in the Beam field at
the top right corner of the CCRP Setting
screen.
5. Move the cursor to the X and Y values of
CCRP1. Press the ENT key and input the
CCRP1 position.
CCRP is on the starboard side of the ship when X>0
and is on the port side of the ship when X<0.
6. In the same manner, input the GPS antenna and radar antenna positions.
Similarly, input the third and subsequent CCRPs.
7. Press [0] key and exit the CCRP setting screen.
GPS position:
If you wish to connect multiple GPS systems to a COM port and select a GPS position to be used, select it
through the receiving port setting of the GPS you wish to use.
Reference: Section "4.8 COMMUNICATION PORT SETTING" [II] Reception Port Setting (RX Port)
Radar antenna position:
The radar antenna position changes as the antenna mode is switched between the master mode and the slave
mode by the simplified inter-switch.
Up to 4 locations can be inputted (select one through the receiving port setting when
using the GPS).
1 location can be inputted (another location is reserved as an antenna location).
4-9