4.20
DGPS RECEIVER SETTING
Set to a JRC's DGPS receiver.
This setting is enabled when a JRC's DGPS is connected to the GPS connector of processor unit.
[I] Beacon frequency mode setting (Mode)
Procedures
1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the DGPS Setting menu.
2. Press the [1] key to select the beacon frequency mode.
3. Press the [5] key to send the setting value to DGPS receiver.
[Ⅱ] Beacon frequency setting(Frequency)
This setting is enabled when beacon frequency mode is set to manual.
Procedures
1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the Frequency menu.
2. Enter the beacon frequency.
3. Press the [5] key to send the setting value to DGPS receiver.
4. NAV equipment Setting
→ 4. GPS Setting
→ 2. DGPS Setting
AUTO
: The beacon frequency mod is selected automatically
Manual
: The beacon frequency mod is selected manually
4. NAV equipment Setting
→ 4. GPS Setting
→ 2. DGPS Setting
4-
24
→ 2. Frequency
4