Ricoh B156 Service Manual page 99

[A]
[C]
B456I201.WMF
[H]
7. Pass the connector [A] through the opening [B].
8. Install the tray heater [C] ( x 1).
9. Connect the heater connector [D] to the cable [E].
10. Remove the oil tank [F].
NOTE: Hang the left oil pipe [G] in the notch [H] in the controller box. Then, oil
does not fall from the pipe to the floor.
11. Install the clamp [I].
NOTE: Make sure that the ac cable [J] from the main machine goes behind the
bracket [K].
12. Connect the cable to the ac cable [J]. Then attach the cable with the clamp.
13. Install the oil tank and the rear covers.
NOTE: When you install the oil tank, make sure that the position of the mark
[L] on the oil pipe is as shown in the diagram above. If you do not do
this, the oil is not correctly supplied to the fusing unit.
SM
CÓPIA NÃO CONTROLADA
TRAY HEATER (OPTIONAL PAPER TRAY UNIT)
[D]
1-71
CÓPIA NÃO CONTROLADA
[B]
[G]
[F]
[L]
[E]
[J]
[K]
[I]
B456I292.WMF
B156/B220