Data Overwrite Security Unit (B735); Accessory Check - Ricoh B156 Service Manual

DATA OVERWRITE SECURITY UNIT (B735)

⇒
1.16 DATA OVERWRITE SECURITY UNIT (B735)
BEFORE YOU BEGIN THE PROCEDURE
1. Make sure that the following settings are not at their factory default values:
Supervisor login password
Administrator login name
Administrator login password
If any of these settings is at a factory default value, tell the customer these settings
must be changed before you do the installation procedure.
IMPORTANT NOTE
If the Customer forgets the Supervisor login password after changing it
from the default setting, a service call is required and the NVRAM must be
replaced to reset the Supervisor login and password.
2. Make sure that "Admin. Authentication" – "Machine Management" is ON.
[System Settings] – [Administrator Tools] – [Administrator Authentication
Management] - [Machine Management]
If this setting is OFF, tell the customer this setting must be ON before you do the
installation procedure.
3. Make sure that under Machine Management "Administrator Tools" is enabled
(selected).
[System Settings] – [Administrator Tools] – [Administrator Authentication
Management] – [Machine Management] - [Available Settings]
If this setting is disabled (not selected), tell the customer this setting must be
enabled (selected) before you do the installation procedure.

ACCESSORY CHECK

The B156/B220 uses a Type D Data Overwrite Security Unit. Check the
accessories and their quantities against this list:
Description
1. SD Card ............................................................................... 1
B156/B220
CÓPIA NÃO CONTROLADA
1-60
CÓPIA NÃO CONTROLADA
Rev. 06/2006
Q'ty
SM