Seal Check And Removal - Ricoh B156 Service Manual

Rev. 06/2006
⇒

1.16.1 SEAL CHECK AND REMOVAL

[A]
1. Ensure a customer witness is present when opening the DOSS option.
2. Make sure that:
1) The box has two pieces of tape [A] attached to the corners in the photo,
AND
2) These two tapes are blank.
If you can see "VOID" on the surface of the tape, DO NOT install the
components in the box. Stop this procedure and contact the Technical Hotline
via the e-Lert form on the TSC Website. Retain the box and its contents. Any
tampering of the DOSS option will need to be investigated.
3. If the results of Step 1 are OK, remove the two pieces of tape from the box.
Note: After you remove the tapes, you will see "VOID" written on the box under
the tape [B]. This is normal.
4. The procedures outline in this bulletin needs to be followed if the DOSS option
is replaced due to a failure.
CAUTION
Before you begin any procedure, always turn OFF the machine main power
switch and unplug the power cord.
SM
CÓPIA NÃO CONTROLADA
DATA OVERWRITE SECURITY UNIT (B735)
B735I901.WMF
1-61
CÓPIA NÃO CONTROLADA
[B]
B735I903.WMF
B156/B220