Ricoh B156 Service Manual page 624

FAX UNIT OPTIONS
10. Install the clamps [A] and hold the
⇒
cable with them.
⇒
IMPORTANT: Make sure to attach
⇒
the clamps in the two positions as
shown in the illustration. If you do not
do this, you cannot attach the flat
cable.
Clamp Positions
11. Attach the FCU [C] to the BICU (
NOTE: Make sure that the jumper
switch on the MBU is set to
"On".
12. Carefully push down the MBU.
NOTE: Make sure that the MBU is
installed in the correct position.
If not, an SC occurs (SC819,
SC672 etc.).
13. Remove the speaker assembly [D]
( x 2) if the speaker assembly was
installed.
14. Power ON. If the machine displays
"SRAM has been formatted due to
problem with SRAM", power OFF/ON
again.
B750
CÓPIA NÃO CONTROLADA
x 4).
10
CÓPIA NÃO CONTROLADA
[A]
1 2
[D]
Rev. 06/2005
[B]
B751I102.WMF
[C]
B751I103.WMF
B751I502.WMF
SM