Ricoh B156 Service Manual page 660

BIT SWITCHES
Width and
reduction
I/O rate
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02
No FUNCTION
0-3 Not used
4 File retention time
0: Depends on User Parameter
24 [18(H)]
1: No limit
5 Not used
6-7 Memory read/write by RDS
Bit 7 6
0 0
0 1
1 0
1 1
System Switch 03
No FUNCTION
0 Length of time that RDS is
to temporarily switched on when
7
bits 6 and 7 of System Switch
02 are set to "User selectable"
System Switch 04
No FUNCTION
0-2 Not used
3 Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
B750
CÓPIA NÃO CONTROLADA
A4: A4 (8.3"), no reduction
B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
0: 0 ms/line
25: 2.5 ms/line
5: 5 ms/line
Note:
"40" is displayed while receiving a fax message using AI short
protocol.
Do not change these settings.
1: A file that had a communication error will not be
Do not change this setting.
(0,0): All RDS systems are always locked out.
Setting (0,1), (1,0): Normally, RDS systems are locked out,
Always disabled but the user can temporarily switch RDS on to allow
User selectable RDS operations to take place. RDS will
User selectable automatically be locked out again after a certain
Always enabled time, which is stored in System Switch 03. Note that
if an RDS operation takes place, RDS will not switch
off until this time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
Do not change these settings.
1: Each Quick/Speed dial number on the list is
printed with the dedicated tx parameters (10 bytes
each).
The first 10 bytes of data are the programmed
dedicated tx parameters; 34 bytes of data are
printed (the other 24 bytes have no use for service
technicians).
CÓPIA NÃO CONTROLADA
10: 10 ms/line
20: 20 ms/line
40: 40 ms/line
COMMENTS
erased unless the communication is successful.
COMMENTS
COMMENTS
46
SP No. 1-101-003
SP No. 1-101-004
SP No. 1-101-005
SM