Ricoh B156 Service Manual page 265

Mode No.
5
(Class 1, 2, and 3)
824 NV-RAM Data Upload
NV-RAM Data Upload
825 NV-RAM Data Download
NV-RAM Data
Download
828 Network Setting
50 1284 Compatibility
(Centro)
52 ECP (Centro)
65 Job Spooling
66 Job Spooling Clear:
Start Time
69 Job Spooling
(Protocol)
84 Printing Settings List
90 TELNET
(0: OFF 1:ON)
SM
CÓPIA NÃO CONTROLADA
Use this to copy NVRAM data from the machine to an
SD card.
Imports data from an SD card to the NVRAM.
When data has been normally imported into the
NVRAM, a message appears on the operation panel.
After reading the message, turn the main power switch
off and on.
Validates/invalidates IEEE1284 compatibility.
[0 ~ 1 / 1 / 1 /step]
• 0: Invalidated
• 1: Validated
Validates/invalidates ECP.
[0 ~ 1 / 1 / 1 /step]
This SP is activated only when SP5828-050 is set to "1".
• 0: Invalidated
• 1: Validated
Enables/disables Job Spooling.
[0 ~ 1 / 0 / 1 /step]
• 0: Disabled
• 1: Enabled
Enables/disables Job Spooling Clear when the main
power turns on.
[0 ~ 1 / 1 / 1/step]
• 0: ON (Erases the spooled job in the HDD before the
main power is turned off.)
• 1: OFF (Prints the spooled job in the HDD before the
main power is turned off.)
Enables/disables Job Spooling for each protocol.
[0 ~ 1 / 1 / 1/step]
• 0: Enables Job Spooling
• 1: Disables Job Spooling
Bit switch
Bit 0: LPR
Bit 1: FTP
Bit 2: IPP
Bit 3: SMB
Bit 4: BMLinks
Bit 5: DIPRINT
Bit 6: Reserved
Bit 7: Reserved
Prints the settings list related to NCS parameters.
Turns on/ off TELNET.
[0 ~ 1 / 1 / 1 /step]
• 0: OFF
• 1: ON
5-37
CÓPIA NÃO CONTROLADA
SERVICE PROGRAM MODE
Function / [ Setting ]
B156/B220