Ricoh B156 Service Manual page 90

DATA OVERWRITE SECURITY UNIT (B735)
⇒
1.16.2 INSTALLATION
NOTE: You must install the data overwrite protection unit in SD Card slot 2. But,
the postscript option for this machine is also installed in SD Card slot 2.
Because of this, you must do the SD Card Appli move procedure first (
5.9) if the postscript option is installed and you want to install the Data
Overwrite Security unit. Move the Data Overwrite Security application (slot
3) to the SD Card that contains the Printer/Scanner application (slot 1).
1. If the machine is ON, turn the
operation switch and the main
power switch OFF.
2. If the NIB is installed, disconnect
the network cable.
3. Remove the SD card slot cover [A]
( x1).
4. With the printed side of the SD
card [B] facing the rear of the
machine, install the DOS SD card
in SD card slot C2.
5. If the NIB is installed, reconnect
the network cable.
6. Turn the main power switch ON.
7. Do SP5878 (Option Setup).
8. Exit SP mode.
9. Turn the operation switch OFF, and then turn the main power switch OFF.
10. Turn the main power switch ON.
11. Do SP5990-005 (SP print mode Diagnostic Report).
12. Make sure the ROM number and firmware version on the diagnostic report are
the same as those in the chart below .
[A]: "ROM Number/Firmware Version" – "HDD Format Option"
[B]: "Loading Program" – "GW1a_zoffy" (
"Loading Program" – "GW2a_zoffy" (
Diagnostic Report:
Data Overwrite Security
Unit Type C
Data Overwrite Security
Unit Type D
B156/B220
CÓPIA NÃO CONTROLADA
[A]
"ROM No. / Firmware
Version" [A]
HDD Format Option:
B7355050 / 0.04
HDD Format Option:
B7355060 / 0.03
1-62
CÓPIA NÃO CONTROLADA
[B]
Data Overwrite Security Unit Type C)
Data Overwrite Security Unit Type D)
"Loading Program" [B]
GW1a_zoffy:
B7355050 / 0.04
GW2a_zoffy:
B7355060 / 0.03
Rev. 06/2006
B735I001.WMF
SM