EPSON AcuLaser C4000/C4100/C3000
1.13.2 Controller Configuration
This printer can set the following configurations for each destination. Since
jumper resistors are used for the settings, these settings are determined when
the printers are shipped from the factory.
NOTE: Destination settings as controller configurations of the 120 V
model (LT) for North/South America are not provided.
Destination Setting
120 V model for North/South America
Other destinations
Product Descriptions
1.13.3 External Interface Specifications
This printer is equipped with the following host interfaces.
1. Parallel Interface
2. Ethernet Interface
3. USB 1.1 Interface
4. Optional Interface (Type-B) 1 slot
A4/LT switching
The positions of the respective interfaces are shown in the Figure 1-8
LT is set
A4 is set
Explanation of LEDs
1) Link/receive light (color: green)
2) 100 Base/10 Base light (color: orange)
The host interfaces can be enabled or disabled respectively.
Controller Unit Specifications
-- Standard
-- Standard
-- Standard
USB Interface
Optinal Interface
Optinal Interface
Type-B Conector
Figure 1-8. Positions of Host Interface
Revision F
.
Parallel Interface
IEEEE 1284 B-Type
1)
2)
Ethernet Interface
(100 Base-TX/10 Base-
T)
1-28