Control Panel - Epson AcuLaser C4000 Service Manual

EPSON AcuLaser C4000/C4100/C3000

7.1.3 Control Panel

7.1.3.1 Special Operations
Table 7-11. List of Operating Functions
Function
ROM Module Copy Refer to the description in right column.
Ignore EpsonNet ASP in HDD Turn the power on pressing the Back, Enter and Job
Cancel buttons.
Hex Dump
Support Mode
Initialization of EEPROM
Panel Setting Value
Initialization
Forced Deleting of the Flash
ROM A Module
Refer to 1.14.4. "Special Operations"
Program ROM Update
Maintenance Mode
CPU reset in a Service Call
occurrence.
Detailed Information Display
in a Service Call occurrence
Printing of the Error Sheet
AcuLaser C4100
Operating Method
Product Descriptions
ROM MODULE COPY
1. Make sure that the printer is turned off. Insert a blank ROM module
into the slot A on the main controller and this is a destination
module. (The source module is the one inserted in the slot P.)
2. Turn the printer on while holding down the buttons; [Start/Stop],
[Job Cancel], [Down].
3. As soon as the message "Program Device" is appeared on a
LCD panel, release all other buttons and press the [Up] button and
holding it untill "Complex Exe" is displayed.
4. Press [Up] button until the message "Copy MENU" is displayed.
The special menu items; other than "Copy MENU", are
C A U T I O N
only for development purpose and not intend to be
operated for field service & support purpose.
Never attempt to use other menu items unless
specifically instructed to do so.
5. Press [Enter] button to enter "Copy MENU".
6. Press [Up] buttons until the message "Copy FONT + CODE] is
displayed.
7. Press [Enter] button to start copying the ROM module. When the
message "Copy END" is displayed, the copy operation is completed.
8. Turn the printer off and remove the ROM module from the slot A.
Revision F
7-484