Controller Configuration - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500
PANEL
1-line 20-character LCD, 6 LEDs, 8 buttons
INTERFACES
Standard:
Parallel 1ch
1EEE-1284-compliant bidirectional
B-type connector
Compatibility
Nibble
ECP
Ethernet 100Base/TX, 10Base/T 1ch
Optional:
Type-B - 1 slots (for level 3)
EPSON RIP Station 5300 interface - 1 slot (exclusive)
RTC
Timer function (for job management)
HDD
1 (option)
PRINTER SETTINGS
Made through the panel setting mode, EJL commands, and MIB
PRINTER MODES
Standard: ESC/Page-Color, ESC/Page (B/W), LJ4 mode,
GL2 mode, ESCP2 mode, FX mode (B/W), 1239X
mode (B/W)
PRODUCT DESCRIPTIONS
Optional:
Others:
SUPPLEMENTARY SOFTWARE:
Status sheet
Network Status Sheet
Option I/F Status Sheet*
PS3 Status Sheet*
Font Sample (each mode)
Hex dump
Support mode
Maintenance mode (Engine Status Sheet, for engine)
Only when Type-B level 3 is installed.
*1:
Only when a PostScript3 module is installed.
*2:
INSTALLATION
Installed to the main printer body.

1.2.13 Controller Configuration

The controller board configuration of this printer can be set for the target
market (destination) as indicated below. The settings are made at factory (by
jumper resistor).
The factory default setting for the paper size (A4 or Letter)
For North and South America:Letter
For Europe, the Pacific / Russia, Taiwan, China and Korea: A4
The default paper size (EXE or B5) for paper cassette
For North and South America, Europe, and the Pacific/Russia : EXE
For Taiwan, China and Korea: B5
Specifications
Postscript3 (PostScript3 module, Peacock-B)
EJL mode, PJL mode, RCC mode, DIAG mode
1
2
Revision C
1-27