Daewoo MUSSO Service Manual page 560

1E2-8 M161 ENGINE ELECTRICAL
Replacement Procedure
1. Unscrew the three screws(1) and remove the ignition coil
cable cover
Installation Notice
Tightening Torque
2. Disconnect the cable from ignition coil and spark plug.
3. Unscrew two bolts(M6 X 25) from each ignition coil and
remove the ignition coil(arrow) .
Installation Notice
Tightening Torque
4. Using the special tool, remove the spark plug .
Installation Notice
Tightening Torque
Clearance
Notice
Tighten the spark plug with specified torque.
Install the ignition coil to number 2 and 4 cylinder, and
connect the cable to number 1, 4 and 2, 3 cylinder
- T1/1 : cylinder 1 and 4
- T1/2 : cylinder 2 and 3
9 - 11Nm
9 - 11Nm
25 - 30 Nm
0.8 + 0.1 mm
Spark Plug Wrench 119 589 01 09 00