Daewoo MUSSO Service Manual page 850

Removal & Installation Procedure
1. Disconnect actuator connector and unscrew bolt and remove
actuator assembly.
Notice
When installing the actuator to the mounting bracket, the
wiring should face the front of the frame.
2. Unscrew the upper nut (6).
Notice
When screwing the nut, actuator contacting surface of the
mounting bracket and rod end should be 0.5 - 1.5mm.
3. Remove the mounting bracket (5).
Notice
When installing the bracket, it should be vertical to the frame
side member.
4. Remove the bush and check for damage and replace if
necessary.
5. Unscrew shock absorber lower bolt and nut and remove
the shock absorber.
Notice
Shock absorber is filled with gas, never attempt to cut or
heat.
6. Installation should follow the removal procedure in the
reverse order.
FRONT SUSPENSION 2C-11