Daewoo MUSSO Service Manual page 846

Removal & Installation Procedure
1. Remove the fixing nuts and bolts of the shock absorber
and lower arm connection.
Installation Notice
Tightening Torque
2. Remove the connecting nuts of the stabilizer bar link to the
lower arm.
Installation Notice
Tightening Torque
3. Turn the height control bolt until the distance between the
end of the height control bolt end piece and the bolt end
becomes 0-5 mm.
Installation Notice
Install the torsion bar spring and adjust the distance between
the end of the height control bolt and piece end the bolt
end to be 50-55 mm. Adjust the vehicle height.
4. Remove the torque arm fixing nuts and bolts and then
withdraw the torsion bar spring.
Installation Notice
Tightening Torque
5. Installation should follow the removal precedure in the
reverse order.
6. Check and adjust the wheel alignment.
60 - 80 Nm
16 - 22 Nm
M10
40 - 60 Nm
60 - 80 Nm
M12
FRONT SUSPENSION 2C-7