Daewoo MUSSO Service Manual page 111

1B1-36 M162 ENGINE MECHANICAL
Tools Required
000 589 01 10 00 Box Wrench Insert
116 589 02 34 00 Screw-fixed Pin
116 589 20 33 00 Sliding Hammer
Removal & Installation Procedure
1. Rotate the crankshaft so that the piston of number 1 cylinder
is at TDC.
Notice
Rotate the crankshaft in the normal engine direction.
2. Put the alignment marks (arrows) on the timing chain and
camshaft sprocket.
3. Drain the coolant from the crankcase.
4. Remove the three flange bolts in the exhaust camshaft
sprocket.
Installation Notice
Tightening Torque
Do not reuse the removed bolts.
5. Separate the chain from the camshaft sprockrt.
Notice
Be careful not to drop the chain into the timing case.
1st step 18 - 22 Nm
2nd step 90° ± 5°