Daewoo MUSSO Service Manual page 910

3D-10 REAR DRIVE AXLE
6. Separate the lower shock absorber from the axle housing.
Installation Notice
Tightening Torque
7. Remove the upper arm mounting nuts and remove the
upper arm form the axle housing.
Installation Notice
Tightening Torque
8. Remove the stabilizer bar.
Installation Notice
Tightening Torque
9. Remove the lateral rod mounting nuts and remove the
lateral rod from the axle housing.
Installation Notice
Tightening Torque
10. Lowering the axle housing slowly, remove the coil springs
and spring seats.
11. Installation should follow the removal precedure in the
reverse order.
50 - 65 Nm
150 - 180 Nm
30 - 45 Nm
150 - 180 Nm