Daewoo MUSSO Service Manual page 283

1B2-92 M161 ENGINE MECHANICAL
1. Check the piston ring gap and apply the engine oil to the
piston pin and the connecting rod bushing.
2. Connect the piston and the connecting rod by pressing in
the piston pin (6) and install the snap ring to the groove.
3. Clean the cylinder bore, connecting rod bearing journal,
connecting rod bearing shell and the piston and coat them
with engine oil.
4. Install the piston ring using the tensioning strap(000 589
04 14 00).
5. Install the piston so that the arrow on the piston head faces
to the forward of the vehicle.
6. After aligning the connecting rod and the bearing cap mark
(// or a number), tighten the bolts.
Installation Notice
Tightening Torque
Apply the engine oil to the bearing cap upper and lower
bearing shells.
7. Check if the crankshaft rotates without any trouble by rotating
it.
1st step 35 - 45 Nm
2nd step 90°+5°