Daewoo MUSSO Service Manual page 262

Adjustment Procedure
1. Position the NO.1 cylinder to ATDC 20° .
2. Remove the chain tensioner.
3. Remove the exhaust camshaft sprocket.
4. Adjust the timing position with inserting the insert pin
( f 6.5mm, 111 589 03 15 00) into the NO.1 and NO.4
camshaft bearing cap hole and flange hole while rotating
the camshaft by using wrench (104 589 01 01 00).
5. Install the chain to the intake camshaft sprocket.
6. Install the chain to the exhaust camshaft sprocket and
tighten the bolt.
Installation Notice
Tightening Torque
The sprocket bolt is designed to be used only once, so
replace with new one.
7. Install the chain tensioner.
Installation Notice
Tightening
Torque
Tensioner assembly
8. Check the camshaft timing.
1st step 20 Nm
2nd step + 90°
Screw plug 40 Nm
80 ± 8 Nm
M161 ENGINE MECHANICAL 1B2-71