Hot Film Air Mass (Hfm) Sensor - Daewoo MUSSO Service Manual

HOT FILM AIR MASS (HFM) SENSOR

1 Housing
2 Protector Net
3 Electronic Housing
Removal & Installation Procedure
1. Turn the HFM sensor coupling in the direction shown in the
figure in the right so that it gets separated from the contact
surface.
Notice
Make sure the HFM sensor coupling connects completely
with the contact surface Installation.
2. Remove the clip with a screw driver.
3. Pry off two tensioning clamps.
4. Remove the HFM sensor.
5. Installation should follow the removal procedure in the
reverse order.
M162 ENGINE CONTROLS 1F1-69
4 Connector
5 Hot film Sensor
6 Measuring Port