Daewoo MUSSO Service Manual page 248

Removal & Installation Procedure
1. Unscrew the connecting rod bearing cap bolt and remove
the bearing cap.
Installation Notice
Tightening Torque
Make sure that the upper and lower bearing shells do
not change each other.
Coat the bearing shell with engine oil.
Install the bearing cap according to the consecutive
number.
2. Unscrew the crankshaft bearing cap bolts and separate
the upper and lower bearing shells and thrust washers.
Installation Notice
Tightening Torque
Remove the bearing cap from front (pulley side) to
rear.
Make sure that the upper and lower bearing shells do
not change each other and coat with engine oil.
The oil grooves (arrows) in the thrust washers must
face outward and insert the thrust bearing into the
bearing cap.
There are five kinds of thrust washers by thickness.
Select the proper washer when repaired.
3. Remove the crankshaft.
4. Installation should follow the removal procedure in the
reverse order.
5. After completion of the installation, check for the rotating
condition of the crankshaft.
Installation Notice
Make sure the crankshaft bearing cap properly seated
in place in the crankcase side. When perfectly
installed, the projected part (arrow) locates in the left
side (intake manifold side).
Assemble so that the projected part of the cap and
crankcase face the same direction.
40 Nm + 90°
55 Nm + 90°
M161 ENGINE MECHANICAL 1B2-57
Part No. : 601 030 00 62
Part No. : 601 030 01 62
Part No. : 601 030 02 62
Part No. : 601 030 03 62
Part No. : 601 030 04 62
2.15 mm
2.20 mm
2.25 mm
2.30 mm
2.40 mm