Daewoo MUSSO Service Manual page 126

Inspection
1. If the length 'L' of the crankshaft bearing cap bolt exceeds
63.8mm, replace it.
2. Make sure the crankshaft bearing cap is properly seated
on the cylinder block (arrows).
3. Measure and record the inner diameter of the crankshaft
bearing.
Notice
Measure at 2 points (1, 2).
Measure 'A','B'and 'C' as shown. If average value of 'B'
and 'C'is less than value 'A', then the average value of
'B' and 'C' is actual average value. If average value of
'B' and 'C' is more than value 'A'is actual average value.
4. Measure and record the diameter of the crankshaft bearing
journal.
Notice
Record the mean value when measured at 3 points (A,
B, C).
Measure the inner diameter of bearing and the diameter
of journal and if it is out of the standard data, replace
the bearing shell.
M162 ENGINE MECHANICAL 1B1-51