Daewoo MUSSO Service Manual page 938

Removal & Installation Procedure
1. Remove the oil level sensor connector.
2. Remove the tube from the master cylinder.
Installation Notice
Tightening Torque
Notice
Be careful not to drop the oil when removing the tube.
If the oil is dropped, promptly sweep up.
3. Remove the booster vacuum hose.
Notice
Connect fully to the end of vacuum hose when installing.
4. Loosen the nut of master cylinder.
Installation Notice
Tightening Torque
5. Remove the clevis pin and disconnect the pedal and brake
booster push rod.
Notice
Install in the upper hole when PBR brake.
Connect the snap pin in the hole of clevis pin fully.
Apply the grease around the hole of clevis pin.
15 - 19 Nm
14 - 22 Nm
POWER BOOSTER 4C-3