Daewoo MUSSO Service Manual page 131

1B1-56 M162 ENGINE MECHANICAL
Removal & Installation Procedure
1. Turn the crankshaft to the direction of engine rotation and
position the no.1 cylinder piston at TDC which the camshaft
is positioned at OT.
2. Remove the cylinder head front cover.
3. Paint the alignment marks (arrows) on the intake and
exhaust camshaft sprocket and the timing chain.
4. Unscrew the bolt (3) from the armature (4) and remove the
armature.
Installation Notice
Tightening Torque
5. Unscrew the nut (6) and remove the ring and seal cover
(11).
Installation Notice
Tightening Torque
6. Unscrew the sprocket bolt from the exhaust camshaft and
remove the sprocket.
Installation Notice
Tightening Torque
The sprocket bolt is designed to be used only once, so
always replace with new one.
35 Nm
60 - 70 Nm
1st step 18 - 22 Nm
2nd step 90° ± 5°
3 Bolt
4 Amarture
6 Nut (M20 x 1.5)
11 Seal Cover
12 Camshaft Sprocket
17 Control Piston
21 Intake Camshaft