Fujitsu Siemens Computers PRIMERGY RX100 S4 User Manual page 32

Chapter 1 Overview
1
Open the rack door.
2
Make sure that the CD-ROM drives are empty.
3
Press the power switch of the display and peripheral devices.
4
Press the power switch on the front of the server with a penpoint or thin object.
The server's power LED turns green. When the power is turned on, the server performs "Power
On Self Test (POST)" which checks the devices of the server. If any errors are detected by POST,
error messages appear.
"9.2.2 Error Messages" (pg.233)
The server turn off time can be set with the ASR setting (on the [Power On/Off] tab) using ServerView
supplied with this server. For details, refer to "3.4 Serious Error Handling (ASR)" in "ServerView User's
Guide" on the PRIMERGY Document & Tool CD.
If you press the [F12] key immediately after the POST memory amount check, the Boot Menu is
displayed, where you can change the boot disk ( "
32
The server's
Power switch
power LED
turns green
■
How to Start the BIOS Setup Utility" (pg.205)).