Fujitsu Siemens Computers PRIMERGY RX100 S4 User Manual page 25

d LAN connector 1 (
This is a LAN port. The applicable cable and meanings of the LEDs are the same as those for
LAN connector 1.
By connecting LAN cable, Remote Management Controller function can be used by Web
interface. To use Remote Management Controller, refer to "Appendix D Remote Management
Controller" ( pg.273).
e Serial port (9 pin) (
Cables of peripheral devices conforming to the RS-232C standard such as modems are plugged
in.
f Display connector (15 pin) (
A display cable is plugged in.
g Mouse connector (6 pin) (
A mouse is plugged in.
h Keyboard connector (6 pin) (
A keyboard is plugged in.
i Rear maintenance LED ( )
When the server is not turned on (standby mode), this LED is on in amber.
This LED turns on or blinks in amber when an error is detected in the server components.
If this LED is on or blinking, contact an office listed in the "Contact Information" of "Start
Guide".
j System identification LED (
This LED is used for maintenance. When pressing the System identification LED button, the
front and rear system identification LEDs turn on blue so that the locations of devices being
maintained can be determined. Also, the "System Identification LED Display" button of
ServerView can be used to turn them on.
)
1
)
)
)
)
)
ID
PRIMERGY RX100 S4 User's Guide
1
25