Installing The Lan Driver - Fujitsu Siemens Computers PRIMERGY RX100 S4 User Manual

4.3 Installing the LAN Driver

This section explains the procedure for installing the driver.
In addition to the case where the OS is installed manually, the driver must be installed
when a LAN card is added.
Checking the LAN device after OS installation
For Windows Server 2003 x64 and Windows Server 2003, the LAN driver installation procedure differs
depending on whether the network adapter was recognized during the OS installation. Check whether or
not a recognized network adapter is present by the following procedures in advance.
1
Click [Start] → [Administrative Tools] → [Computer Management].
2
Click [Device Manager].
On the Device Manager list, check if a recognized network adapter is present.
(Window example)
When a recognized network adapter is present, [Network adapters] appears.
When a recognized network adapter is present
Perform " Updating LAN Drivers" ( pg.128) on the LAN device name under [Network adapters],
then " Installing the LAN Driver" ( pg.129) on [Ethernet controller] under [Other devices].
When a recognized network adapter is not present
Perform " Installing the LAN Driver" ( pg.129) on [Ethernet controller] under [Other devices].
When installing the driver, open the Ethernet controller properties and check the corresponding
controller.
• Onboard LAN 1 corresponds with PCI bus 8, device 4, and function 1
PRIMERGY RX100 S4 User's Guide
Recognized
network adapter
Unrecognized
network adapter
4
125