Remote Power Supply Control - Fujitsu Siemens Computers PRIMERGY RX100 S4 User Manual

C Remote Control Function
C.2

Remote Power Supply Control

This section explains how to control the server power supply remotely.
The server power supply can be remote-controlled with the terminal software on the PC.
■ Starting Up the Remote Controller
1
Start up the terminal software.
The remote control window appears.
****************************************
* Welcome to PRIMERGY Remote Manager
* Firmware Revision x.xxA (x.xx)
* SDRR *.**
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type
System ID
System Name
System OS
System Status: OK
Power Status : On
Please enter user name :
Please enter pass phrase :
Power state is displayed next to "Power Status".
On
Off
2
When "Please enter user name:" appears, enter the user name and press the
[Enter] key.
3
When "Please enter pass phrase:" appears, enter the password and press the
[Enter] key.
Note that the password is case-sensitive. As shown below, the characters you have entered are
displayed as asterisks.
Please enter pass phrase : *****
270
ID 0203 RX100S4
: PRIMERGY RX100 S4
: xxxxxxxx
: RX100S4-2 (xxx.xxx.xxx.xxx)
: xxxxxxxx
table: Meaning of [Power Status]
Display
The server is turned on.
The server is turned off.
*
*
*
Description