Restoring The System - Fujitsu Siemens Computers PRIMERGY RX100 S4 User Manual

Chapter 9 Operation and Maintenance
• Replacing with a larger hard disk
●
Reducing the installed memory to collect the memory dump
To obtain memory dump regardless of the installed memory size, reduce the installed memory to an
obtainable size.
Check the memory dump settings when changing the installed memory size.
For setting procedures, refer to "5.1 Memory Dump/Paging File Setting" ( pg.134).
●
Changing the write type of the debugging information
If the memory dump cannot be collected, select a write type of debugging information within the range
of free space of the volume size.
If the above does not provide a solution, try increasing the size of the hard disk or adding an additional
hard disk.

■ Restoring the System

In the unfortunate event where the system file, system configuration, or environment changes during
startup are corrupted, use the repair information stored on the recovery disk created at the installation to
restore the system.
For restoration procedures, refer to the following:
• "9.6.1 For Windows Server 2003/Windows Server 2003 x64" ( pg.256)
• "9.6.2 For Windows 2000 Server" ( pg.257)
■ Failed in Remote Installation
If remote installation fails, check the following.
●
Checking Services
Check that the DHCP, PXE Service, and TFTP Service are running.
For checking procedures, refer to "3.4 Remote Installation" ( pg.86).
●
Setting TFTP
To access TFTP Service, add a Guest account to the TFTP folder and set appropriate access rights.
For setting procedures, refer to "3.4 Remote Installation" ( pg.86).
●
Checking Network Function Settings
The server must support network startup (PXE).
For the setting procedures, refer to "Remote installation" in "2.1.2 Hardware Settings" ( pg.41).
●
Checking the MAC Address
Check that the current MAC address is the correct MAC address of the server.
For the MAC address checking procedures, refer to "Remote installation" in"2.1.2 Hardware Settings"
( pg.41).
242