Installing An External Antenna - Toro TIS-240 User Manual

Installing an External Antenna

The external antenna kit (TIS-ANT) is designed to increase the
reception of the ET Everywhere data transmission.
For best results, install the antenna as high above the controller as
possible without straining the cable. The antenna must be oriented in
a vertical position away from any power source.
Note: In some cases, the controller may need to be relocated to obtain
acceptable reception.
1. Open the controller door and control module.
2. Remove the plastic hole plug in the base of the cabinet.
3. Route the antenna cable through the base of the cabinet and
attach the cable connector to the receptical provided on the
back of the control module.
4. For smooth surface walls, simply attach the antenna using the supplied
foam tape. When installing the antenna on a rough or uneven surface,
use the provided clamps and screws.
5. Close the control module. Change the antenna setting from Internal
to External as described in "Radio Antenna Option"on page 50.
Antenna Kit
TIS-ANT
75