Toro TIS-240 User Manual page 24

Note: When the Intelli-Sense is operating in an ET-controlled mode,
it will attempt to run irrigation on all active days as needed. During
months of low ET rate, some active days may be skipped. While in
the summer months, with generally high ET rate, every active day
may be needed to provide the required amount of irrigation. If too
many days are excluded from the schedule to enable the required
irrigation to occur, a Day Pattern Alert condition will result.
See "Day Pattern Alert" on page 56 for additional information.
1.
Within the Select Water Days menu, turn the Lower Line knob
to view the following display:
SELECT WATER DAYS
Days of Week
Turn the Upper Line knob to the right to display day schedule
2.
per month.
Jan S M T W T F S
Y Y Y Y
3. To remove a day from the schedule, turn the Upper Line knob
to select (underline) the day.
Note: Moving the underline past Saturday will advance the display
to the next month in sequence.
4. Turn the Lower Line knob to replace the Y with a dash (–). In the
example below all Fridays in January are excluded for Schedule A.
Jan S M T W T F S
Y Y Y Y Y – Y
5. Repeat steps 2 – 4 for all remaining months.
20
SCH A
SCH A
Y Y
Y
SCH A