Microzone Number
The Microzone number identifies the location of the controller
and enables it to receive specific ET Everywhere data. This number
is downloaded automatically during the ET Everywhere service
activation.
1.
Within the Help menu, turn the Upper Line knob to view the
following display:
MICROZONE
12345678
The default number will be initially displayed. During ET
Everywherer service activation, the actual microzone number
will be automatically downloaded.
Phase Integrity
1.
Within the Help menu, turn the Upper Line knob to view the
following display:
PHASE INTEGRITY
A=00
The controller will begin acquiring signal strength data which
will be displayed next to each of the identifiers (A, B, C and D).
This information will be used during the initial ET Everywhere
setup process to identify the strongest signal.
Lock Phase
Note: At the time of ET Everywhere Service activation, you will be
assisted by a WeatherTRAK customer support representative in the
Lock Phase selection procedure. Do not change the default setting
until that time.
1.
Within the Help menu, turn the Upper Line knob to view the
following display:
LOCK PHASE
None
Turn the Lower Line knob to select the appropriate Phase
2.
identifier (A, B, C, D or None).
B=00
C=00
*
D=00
51