Final Gear Case Assembly - Honda VT750C2 Shadow Spirit Service Manual

FINAL DRIVE
14-21
- - - - - - - - - - - ­
-
- ­
- - - - - - - - - - - ­ - - - ­
Keep dust and dirt
out of the case and
cover.
FINAL GEAR CASE ASSEMBLY
NOTE:
When the gear set, bearing and/or gear case has
been replaced, check the tooth contact pattern (page
14-9) and gear case backlash (page 14-8).
Clean the mating surface of the gear case and cover,
being careful not to damage them.
Apply liquid sealant to the mating surface of the
gear case.
Install the wave washer.
Install the case cover onto the gear case.
Apply locking agent to the threads of the case cover
10 mm bolts.
Install the bolts, and tighten them in a crisscross
pattern in several steps until the cover evenly
touches the gear case.
Tighten the two 10 mm bolts to the specified torque
in several steps alternately.
TORQUE: 47 N·m (4.8 kgf·m, 35 Ibf·ft)
Tighten the six
8
mm bolts to the specified torque in
a crisscross pattern in several steps.
TORQUE: 25 N·m (2.5 kgf·m, 18 Ibf·ft)
Apply
gre~se
to a new G-ring.
Install the G-ring in the ring gear groove.
Check thatthe gear assembly turns smoothly with ­
out binding.
ME;lasurethe final gear assembly pre-load.
STANDARD:
0.2 - 0.4 N·m (2 - 4 kgf·cm, 0.1 - 0.3 Ibf·ft)
If the preload reading does not fall within the speci­
fication, oheck the bearings for proper installation.
WAVE WASHER
..--­
fI
G-RING