- - - - - - - - - - - - - - - - - -
FINAL DRIVE
RING GEAR REMOVAL/SHIM
REPLACEMENT
Remove the final gear case cover (page 14-9).
If the ring gear stays in the cover, remove it as fol
lows:
Press the ring gear out of the gear case cover using
the special tools and hydraulic press.
TOOLS:
Driver
07749·0010000
Oil
seal driver attachment
07LAD-SM40100 or
07LAD-SM4A100
(U.S.A. only)
Remove the oil seal.
If the bearing remained in the cover, remove it as
follows:
Press the ail seal and bearing out of the cover using
the special tools and hydraulic press.
TOOLS:
Driver
07749-0010000
Oiheal
driver
070MF·MEG0300
Attachment, 72 x 75 mm
07746-0010600
If the bearing remained on the ring gear, remove it
as follows:
Remove the ring gear bearing using a commercially
avaiiapJe/bearingpulier.
This. b.earing may not need to be replaced after
rem~qvaLHoWever,
inspect the bearing for excessive
play after removal.
Replace it if necessary.
14-11