IGNITION SYSTEM
The timing is correct if the "F" mark on the flywheel
"F"
MARK
aligns with the index notch on the left crankcase
cover.
Coat a new a-ring with engine oil and install it into
the timing hole cap groove.
Apply grease to the threads of the timing hole cap.
Install the timing hole cap and tighten it to the spec
ified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 Ibf·ft)
Install the alternator cover and tighten the socket
bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 Ibf·ft)
,
a-RING
"
INDEX NOTCH
TPSENSOR
INSPECTION
Remove the ICM (page 19-9).
Measure the resistance between the Yellow/red and
Blue/green wire terminals of the wire harness side
connector.
STANDARD: 4 - 6 k.Q (20°C/68°F)
Check that the resistance between the Red/yellow
and Blue/green wire terminals varies with the throt
tle position while operating the throttle grip.
Fully open - Fully closed position:
Resistance decreases
Fuliy closed - Fully open position:
Resistance increases
19-10