- -
- - - -
- - - - - - - - - - - - - - - - -
LIGHTS/METERS/SWITCHES
SIDESTAND SWITCH
Do not reuse the
sidestand switch
bolt.
INSPECTION
Remove the seat (page 3-3).
Disconnect the sidestand switch 2P (Green) connec
tor.
Check for continuity between the switch side con
nector terminals.
There should be continuity with the sidestand
retracted and no continuity with the sidestand low
ered.
REMOVALlINSTAlLATION
Remove the following:
-
Seat (page 3-3)
-
Left side cover (page 3-3)
-
Left crankcase rear cover (page 3-5)
Support the motorcycle securely.
Disconnect the sidestand switch 2P (Green) connec
tor.
Release the sidestand switch wire from the wire
bands and clamps.
Remove the bolt and sidestand switch.
Install the sidestand switch by aligning its pin with
the sidestand hole and switch groove with the
bracket pin.
...
--"""'"=-....
21-20