Ring Gear Assembly - Honda V65 MAGNA Shop Manual

DRIVE TRAIN
Place the pinIOn assembly into the gear housing.
Drive the pinion assembly into the gear case until
pinion retainer threads can engage with the case
threads.
Apply gear oil to the a-ring and threads on the
pinion retainer. Install the a-ring guide tool.
Screw in the pinion retainer to press the pinion
bearing in place, then tighten it to the specified
torque.
TORQUE:
100-120 N'm (10-12 kg-m, 72-87 ft-Ib)
RING GEAR ASSEMBLY
Install the original spacer onto the ring gear.
NOTE:
If the gear set, pinion bearing, ring gear bear-
ing and/or gear case is replaced, install a 2.0
mm thick spacer.
ATTACHMENT
07931-4630300
RING GEAR SPACER
V65MAGNA
RETAINER WRENCH
07910-ME80000
Place a new ring gear bearing on the ring gear shaft.
Place the old bearing on top of it. Then, drive the
new bearing onto the shaft with the old bearing and
attachment. Then remove the old bearing.
1 -12
216
Date of Issue: Dec, 1982
©
HONDA MOTOR CO., LTD.