Brake/Tail Light - Honda VT750C2 Shadow Spirit Service Manual

BRAKE/TAIL LIGHT
BULB REPLACEMENT
Remove the screws.
Remove the brakeltail light lens while pushing it
down and release its tabs from the rear fender A.
LENS
While pushing in the bulb, turn it counterclockwise
to remove it, and replace it.
Make sure that the lens gasket is installed in posi­
tionand is in good condition, and replace it with a
new one if necessary.
Install the removed Pl;Irts in the
removal.
reverse order of
GASKET SCREWS
LIGHTS/METERS/SWITCHES
Align
TURN SIGNAL LIGHT
Route the turn
signa/light wire
properly
(page 1-22).
REAR
Remove the rear frame/rear fender A (page 3-7).
Release the turn signal light wire from the clamps of
the rear frame.
Remove the bolt and turn signal light from the rear
frame.
Install the turn signal light, aligning its tab with the
rear frame slot and tighten the bolt.
Install the rear frame/rear fender A (page 3-7).