ALTERNATORISTARTER CLUTCH
FLYWHEEL INSTALLATION
During woodruff
key installation, be
careful not
to
damage the key
groove or
crankshaft.
The flywheel bolt
has left hand
threads.
Install the woodruff key to the key groove of the
crankshaft.
Apply engine oil to the needle bearing and install it
to the crankshaft.
Install the washer to the crankshaft.
Wipe any oil off the mating surface of the crank
shaft.
Wipe any oil off the mating surface of the flywheel.
Install the flywheel to the crankshaft, aligning the
key groove of the flywheel with the woodruff key on
the crankshaft.
Hold the flywheel using a special tool.
TOOL:
Flywheel holder
07725-0040001 or
equivalent com
mercially avail
able in U.S.A.
Apply engine oil to the flywheel bolt threads and
seating surface. .
Installa~d
tighten the flywheel bolt with the washer
to the specified torque.
TORQUE: 128 N'm (13.1
kgf·m,94lbf·ft)
Apply engine oil to the starter reduction gear and
starter idle gear shaft outer surface.
Install the starter reduction gear, idle gear and
shafts to the left crankcase as an assembly.
NOTE:
Install the sta.rter reduction gear with its "OUT" mark
facing out.
Install the stator and left crankcase cover
(page 12-11).
12-10