LIGHTS/METERS/SWITCHES
Connect the speedometer 12P connector and install
12P CONNECTOR
the dust cover.
Install the speedometer assembly on the fuel tank,
aligning the fuel tank tab with the meter slot.
Install and tighten the bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf'm, 7 Ibf·ft)
VS SENSOR INSPECTION
Remove the seat (page 3-3).
Disconnect the VS sensor 3P (Natural) connector.
Turn the ignition switch to ON and measure the
voltage at 3P (Natural) connector of the wire har
ness side.
CONNECTION: Brown
(+) -
Green/Black (-)
STANDARD:
Battery Yoltage
There should be battery voltage.
If there is no voltage, check for an open circuit in the
Brown and Green/black wires.
Support the motorcycle securely and raise the rear
wheel off the ground.
Connect the test harness between the VS sensor 3P
(Natural) connector.
TOOL:
Inspection test harness
07GMJ-MLB0100
Measure the voltage between the Red clip
(+)
and
White clip (-).
CONNECTION: Red clip
(+) -
White clip (-)
STANDARD:
Repeat 0 to 5 V
Shift the transmission into neutral and turn the igni
tion switch to ON.
Slowly turn the rear wheel by hand.
If pulse voltage does not appear, replace the VS sen
sor.
VS SENSOR REPLACEMENT
Remove the following:
-
Seat (page 3-3)
-
Left side cover (page 3-3) .
-
Left crankcase rear cover (page 3-5)
Disconnect the VS sensor 3P (Natural) connector.
21-11