Master Cylinder; Brake Disc Inspection - Honda VT750C2 Shadow Spirit Service Manual

HYDRAULIC BRAKE
Install the pad pin by pushing in the pads against
the pad spring to align the pad pin holes in the pads
with the caliper body.
Tighten the pad pin to the specified torque.
TORQUE: 18 N·m (1.8 kgf'm, 13 Ibf·tt)
Install the pad pin plug and tighten it to the speci­
fied torque.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 Ibf·tt)
Operate the brake lever to seat the caliper piston
against the pads.
BRAKE DISC INSPECTION
Visually inspect the disc for damage or cracks.
Measure the brake disc thickness at several points.
SERVIC~
LIMIT: 5.0 mm (0.20 in)
Measure the brake disc warpage with a dial indica­
tor.
SERVICEUMIT:·0.30mm (0.012 in)
Checkthe bearing for excessive play, if the warpage
exceeds the service limit.
. Replace the brake disc if the bearings are normal.
For brake disc replacement (page 15-15).
MASTER CYLINDER
DISASSEMElLY
-:'~:,:"':~~i:"~:;;;;-
Drain the'°f)raka fluid from the hydraulic system
(page 17-5):
Remove therearview mirror.
When removing the
Remove the oil bolt and sealing washers.
oil bolt, cover the
Disconnect the front brake light switch connectors.
end of the hose to
prevent
contamination.
17-8