Sidestand - Honda VT750C2 Shadow Spirit Service Manual

MAINTENANCE
The adjuster may
Minor adjustment is made with the upper adjuster
be damaged if it is
at the clutch lever.
positioned too far
Loosen the lock nut and turn the adjuster as
out, leaving minimal
required.
thread
Tighten the lock nut while holding the adjuster.
engagement.
If the adjuster is threaded out near its limit and the
correct freeplay cannot be obtained, turn the
adjuster all the way in and back out one turn.
Tighten the lock nut and make major adjustment
(page 4-23).
Major adjgstrnent is made with the lower adjusting
nut at the e,ngirie.
Loosen the lock nut and turn the adjusting nut as
required.
After adjustment is complete, tighten the lock nut
while holding the adjusting nut.
Check the clutch operation.
If the freeplay cannot be obtained, or the clutch slips
during the test ride, disassemble and inspect the
clutch (page 11-7).
SIDESTAN
0 ,
~ol~them~19rcY~lein
an upright position.
Check the
~id~§!Cl{la'c?spring
for damage or loss of
tension. , " ,­
Check th~sidEls~aDd assembly for freedom of move­
mentandlubii.c~f~the
sidestand pivot if necessary.
Checkthesjdest~r¥igniti9n
cut-off system:
-~it.~'.Cl~~ri~~themotorcycle
and raise the side-
l;!.~~(t'--"---/.i.-
'. . '
~ .situ theel1gine""it~.~thetransmission in neutral,
thl{n shifftbe - transTission into gear, while
squeezing tbe-9h.itl<lJl~ver.
- Fully lower the'$ioestand;
-
The engine~b()iJldst6p as the sidestand is low­
ered.
If there is .a problElI11....,ith the system, check the side­
standsl!lfitch
(pag~21-20).
LOCK NUT
ADJUSTER
SIDESTAND
4-23