Verifying Basic Connectivity And The Configuration; Displaying Basic Connectivity Configurations - Juniper J-series Services Router J2350 Hardware Manual

Table 45: Configuring Basic Settings (continued)
Task
Define the backup router
to be used when the
router is booting or the
routing protocol processes
are not running.
Define the IP address for
.
lo0.0
Define the IP address for
.
ge-0/0/0

Verifying Basic Connectivity and the Configuration

To verify that the Services Router has the settings you configured, perform the
following task:
J-Web Configuration Editor
In the Backup router section, next to Address, type the IP
address of the backup router—for example,
1. In the configuration editor hierarchy, next to Interfaces,
click Configure or Edit.
2.
In the Interface table, locate the
3. In the Unit table, click 0, and in the Family section
next to Inet, click Configure or Edit.
4. To delete the existing IP address, click the Discard
button. Select the Delete Configuration Below This
Point option button from the next display.
5. Next to Address, click Add new entry.
6. In the Source box, type the address and prefix length
for the loopback interface—for example,
172.16.1.24/32 .
7. Click OK.
1. In the configuration editor hierarchy, next to Interfaces,
click Configure or Edit.
2. In the Interface table, locate the
Unit.
3. In the Unit table, click 0, and in the Family section
next to Inet, click Configure or Edit.
4. To delete the existing IP address, click the Discard
button. Select the Delete Configuration Below This
Point option button from the next display.
5. Next to Address, click Add new entry.
6. In the Source box, type the address and prefix length
for the management interface—for example,
192.168.1.1/24 .
7. Click OK.
Displaying Basic Connectivity Configurations on page 114
Chapter 6: Establishing Basic Connectivity
CLI Configuration Editor
Set the address for the backup
router. For example:
192.168.2.44 .
set backup router 192.168.2.44
1.
lo0 row and click Unit.
2.
3.
1.
row and click
ge-0/0/0
2.
Verifying Basic Connectivity and the Configuration
From the [edit] hierarchy level,
enter
edit interfaces
Delete the existing IP address:
delete lo0 unit 0 family inet
address
Set the IP address and prefix
length of . For example:
lo0.0
set lo0 unit 0 family inet
address 172.16.1.24/32
Delete the existing IP address:
delete ge-0/0/0 unit 0 family
.
inet address
Set the IP address and prefix
length of . For
ge-0/0/0
example:
set ge-0/0/0 unit 0 family inet
address 192.168.1.1/24
113