J6350 Power System - Juniper J-series Services Router J2350 Hardware Manual

J-series services routers software with enhanced services
Hide thumbs Also See for J-series Services Router J2350:
Table of Contents

Advertisement

The J4350 AC-powered chassis has a power switch and does not include a power
LED.
The J4350 DC-powered chassis includes a power supply LED located to the upper
right of the power supply connector. Table 17 on page 31 describes the power supply
LED.
Table 17: Power Supply LED
State
Off
Green
Yellow
For information about site power preparations, see "Power Guidelines, Requirements,
and Specifications" on page 67. For information about connecting the router to power
and ground, see "Connecting Power" on page 84.
NOTE: You cannot mix DC and AC power supplies in the same chassis.
WARNING: DC-powered Services Routers are intended for installation only in a
restricted access location.

J6350 Power System

The J6350 Services Router uses either AC or DC power. You can install one or two
autosensing, load-sharing power supplies on the system board at the bottom of the
chassis, as shown in Figure 15 on page 22 or Figure 17 on page 23. The power
supplies distribute the different output voltages to the router components, depending
on their voltage requirements. When two power supplies are installed and operational,
they automatically share the electrical load.
For full redundancy, two power supplies are required. If a power supply stops
functioning for any reason, the second power supply instantly begins providing all
the power the router needs for normal functioning. It can provide full power
indefinitely.
Each power supply has an LED located to the upper right of the power supply
connector. Table 17 on page 31 describes the power supply LED.
For information about site power preparations, see "Power Guidelines, Requirements,
and Specifications" on page 67. For information about connecting the router to power
and ground, see "Connecting Power" on page 84.
Description
No power is flowing to the power supply.
Power supply is connected and power is flowing.
Power supply is connected, but the router is not powered on.
J4350 and J6350 Services Router Hardware Features
Chapter 2: J-series Services Router Hardware Features
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

J-seriesJ2320J4350J6350

Table of Contents