Juniper J-series Services Router J2350 Hardware Manual page 133

Table 43: Basic Configuration Wizard Summary (continued)
Prompt
To allow you to configure the management interfaces, the configuration wizard presents
the following information. To configure a specific management interface, enter the number
associated with it at the prompt.
Configure the following network interfaces
Identifier ... Interface
.... 1 ........ ge-0/0/0
.... ........
2 ge-0/0/1
.... ........
3 ge-0/0/2
.... ........
4 ge-0/0/3
Would you like to configure any of the above interfaces [yes, no] (yes):
Please enter one or more identifiers of the interfaces separated by comma.
For example, 1, 2
Please select interface identifiers:
For example, if you enter 1 , the following text and prompt is displayed:
Configure IP on interface ge-0/0/0
IP address for this interface:
After you enter the IP address, the configuration wizard presents the following prompt:
Subnet mask bit length for this interface [1 32] (32):
After you enter the subnet mask for the interface, the configuration wizard presents the
following prompt:
Enter a security zone name to associate this interface to:
Default Gateway
Would you like to configure default gateway? [yes,
no] (no):
If you enter , the configuration wizard
y(es)
presents the following prompt:
Enter IP address for the default gateway:
New User Account
Function
Defines a default gateway through
which to direct packets addressed to
networks not explicitly listed in the
routing table.
Configuring Basic Settings Using the CLI Configuration Wizard
Chapter 6: Establishing Basic Connectivity
Your Action
Type a 32-bit IP address, in
dotted decimal notation.
109