Juniper J-series Services Router J2350 Hardware Manual page 17

Table 1: Tasks and Related Documentation (continued)
Task
Configuring device interfaces
Deployment Planning and Configuration
Understanding and gathering information required to
design network firewalls and IPsec VPNs
Implementing a JUNOS software with enhanced services
firewall from a sample scenario
Implementing a policy-based IPsec VPN from a sample
scenario
Security Configuration
Configuring and managing the following security services:
Stateful firewall policies
Zones and their interfaces and address books
IPsec VPNs
Firewall screens
Interface modes: Network Address Translation (NAT)
mode and Router mode
Public Key Cryptography (PKI)
Application Layer Gateways (ALGs)
Chassis clusters
Intrusion Detection and Prevention (IDP)
Routing Protocols and Services Configuration
Configuring routing protocols, including static routes and
the dynamic routing protocols RIP, OSPF, BGP, and IS-IS
Configuring class-of-service (CoS) features, including
traffic shaping and policing
Configuring packet-based stateless firewall filters (access
control lists) to control access and limit traffic rates
Configuring MPLS to control network traffic patterns
WAN Acceleration Module Installation (Optional)
Installing and initially configuring a WXC Integrated Services
Module (ISM 200)
User and System Administration
Related Documentation
JUNOS Software Interfaces and Routing Configuration Guide
JUNOS Software CLI Reference
JUNOS Software with Enhanced Services Design and
Implementation Guide (J-series Services Routers only)
JUNOS Software Security Configuration Guide
JUNOS Software CLI Reference
JUNOS Software Interfaces and Routing Configuration Guide
JUNOS Software CLI Reference
WXC Integrated Services Module Installation and Configuration
Guide (J-series Services Routers only)
How to Use This Manual
About This Guide
xvii