Network Cable Specifications; Isdn Provisioning - Juniper J-series Services Router J2350 Hardware Manual

JUNOS Software with Enhanced Services Hardware Guide
Table 38: J-series PIM Power Consumption and Heat Dissipation (continued)
Name Model Number
ADSL 2/2+ JX-1ADSL-B-S
Annex B PIM
(1 port, for ISDN)
G.SHDSL PIM JX-2SHDSL-S
(2-port two-wire
mode or 1-port
four-wire mode)
WXC Integrated ISM-200–WXC
Services Module
Table 39 on page 74 lists the maximum power tokens and maximum heat tokens
available for each model.
Table 39: Maximum Power and Heat Capacities of J-series Models
Model
J2320
J2350
J4350
J6350

Network Cable Specifications

The Services Router supports interfaces that use various kinds of network cable. For
information about the type of cable used by each interface, see "Network Cable
Specifications and Connector Pinouts" on page 179.

ISDN Provisioning

You might need a network termination type 1 (NT1) device to connect your ISDN
interface to the ISDN service. Contact your service provider for details on the following
information:
74
Network Cable Specifications
PIM Abbreviation
in JUNOS CLI
1x ADSL Annex B
2x SHDSL (ATM)
wan-acceleration
Low- Power Capacity
(tokens)
50
84
100
100
External NT1 device and ISDN cable
If the two items are required, where to obtain the items
List of NT1 vendors
Tokens
Low Power High Power
16 2
9 –
7 37
High- Power Capacity
(tokens)
50
84
100
100
Heat
16
10
49
Heat Capacity (tokens)
68
84
100
100