Juniper J-series Services Router J2350 Hardware Manual page 135

Table 44: Sample Settings on a Services Router (continued)
Services Router Property
IP address of the DNS server to which DNS requests are sent
Domains to which the Services Router belongs
IP address of a backup router to use while the Services Router
is booting or if the routing protocol processes fail to start
Loopback IP address and prefix length for the Services Router
lo0 interface
IP address and prefix length for the Services Router
interface
You can configure basic settings in the J-Web interface from a device attached to the
ge-0/0/0
Interface" on page 97. You can also connect to the CLI to configure basic settings.
For instructions, see "Connecting to the CLI Locally" on page 98 and "Connecting
to the CLI Remotely" on page 100.
To use a configuration editor to configure basic settings:
1.
2.
3.
4.
Table 45: Configuring Basic Settings
Task
Navigate to the System
level in the configuration
hierarchy.
Define the hostname of
the router.
Name the domain in
which the router is
located.
ge-0/0/0
interface on port 0. For instructions, see "Connecting to the J-Web
Navigate to the top of the configuration hierarchy in either the J-Web or CLI
configuration editor.
To configure basic settings, perform the configuration tasks described in
Table 45 on page 111.
If you are using the J-Web interface, click Commit to view a summary of your
changes, then click OK to commit the configuration. If you are using the CLI,
commit the configuration by entering the
To check the configuration, see Displaying Basic Connectivity
Configurations on page 114.
J-Web Configuration Editor
1. In the J-Web interface, select Configuration>View
and Edit> Edit Configuration.
2. Next to System, click Configure or Edit.
In the Host name box, type the hostname of the router—for
example, .
routera
In the Domain name box, type the domain name of the
router—for example,
lab.router.net
Chapter 6: Establishing Basic Connectivity
Sample Value
10.148.2.32
and
lab.router.net router.net
192.168.2.12/24
172.16.1.24/32
192.168.1.1/24
command.
commit
CLI Configuration Editor
From the
enter
edit system
Set the hostname. For example:
set host-name routera
Set the domain name. For example:
.
set domain-name lab.router.net
Configuring Basic Settings with a Configuration Editor
[edit] hierarchy level,
111